Acer Aspire 7730 Series Service Manual page 162

Hide thumbs Also See for Aspire 7730 Series:
Table of Contents

Advertisement

POST Code
0x6A
Display external cache size on the screen if it is non-
zero.
0x6C
Display shadow message
0xCA
post EISA init
0x70
Check flags in CMOS and in the TrustedCore data
area for errors detected during POST. Display error
messages on the screen.
0x72
Check status bits to see if configuration problems
were detected. If so, display error messages on the
screen.
0x4F
Initialize MultiBoot. Allocate memory for old and new
MultiBoot history tables.
0xCD
Reclaim console vector after HW vectors initialized.
0x7D
Initialize Intelligent System Monitoring.
0x7E
The Coprocessor initialization test. Use the floating
point instructions to determine if a coprocessor
exists instead of the ET bit in CR0.
0xC1
Check Boot Type (Server BIOS)
0x80
Disable onboard COM and LPT ports before testing
for presence of external I/O devices.
0xCA
Redirect Int 15h to enable target board to use remote
keyboard (PICO BIOS).
0x88
Initialize interrupt controller.
0x81
Run late device initialization routines.
0x87
Initialize motherboard configurable devices.
0x85
Display any ESCD read errors and configure all PnP
ISA devices.
0x82
Test and identify RS232 ports.
0x84
Test and identify parallel ports.
0x86
Initialize onboard I/O and BDA according to CMOS
and presence of external devices.
0x83
Configure Fisk Disk Controller.
0xCE
Initialize digitizer device and display installed
message if successful.
0x89
Enable non-maskable interrupts.
0x8C
Initialize both of the floppy disks and display an error
message if failure was detected. Check both drives
to establish the appropriate diskette types in the
TrustedCore data area
0xCB
Redirect Int 13h to Memory Technologies Devices
such as ROM, RAM, PCMCIA, and serial disk (PICO
BIOS).
0xCD
Remap I/O and memory address space for PCMCIA
(PICO BIOS).
0x90
Initialize hard-disk controller. If the CMOS ram is
valid and intact, and fixed disks are defined, call the
fixed disk init routine to initialize the fixed disk
system and take over the appropriate interrupt
vectors.
152
Function
Phase
Component
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
LBT
Core
Chapter 4

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aspire 7730zAspire 7730g seriesAspire 7730zg

Table of Contents