Clearing BIOS Passwords
0
If a BIOS password (Supervisor Password and/or User Password) is set, the BIOS will prompt
for the password at system POST or upon entering the BIOS setup menu. There are two
methods for clearing the BIOS password. A hardware method and a software method.
Hardware Method
0
1. Remove AC adapter.
2. Locate the RTC reset point and short it (A). (Figure 2-29)
A
Figure 2-29. CMOS Jumper
Table 2-5. CMOS Jumper
Item
Description
Clear CMOS
Clear CMOS Jumper (RTC reset point)
3. Plug in AC adapter.
4. Restart the system and press F2 to enter BIOS Utility Setup menu.
5. If no password prompt is shown, BIOS password is cleared.
6. If password prompt is shown, repeat steps 1 through 5.
2-23
System Utilities