Advertisement
Operating Instructions
CAUTION: Charger enclosure may be hot during charging. Use hand protection if handling the charger while charging.
Extension cords must be 3-wire cord no longer than 30m(100') at 10AWG or 7.5m(25') at 16AWG per UL guidelines.
Only connect ONE QuiQ charger to a single 15A circuit or the circuit may become overloaded.
Ammeter
Displays scale of output current
If only ammeter and AC
Indicator LEDs are lit:
Less than 80% state of
charge
If flashing: Output has
been reduced due to
high internal charger
temperature.
Troubleshooting Instructions
If a fault occurs, count the number of red flashes between pauses and refer to the table below.
Flashes
Note: This is a Class A product. In a domestic environment this product may cause radio interference, in which case the
user may be required to take adequate measures.
Charger 10-LED Display
Charge Indicator
If solid: Greater than 80% state of charge
If off: Less than 80% state of charge or pre-charge
Charge Completion Indicator
If solid: Charging is complete
AC Indicator
If solid: AC power is present.
If flashing: Low AC voltage. Check electrical source and cord length.
Fault Indicator
Charger error. Refer to troubleshooting information below.
Receptacle Display
LED
Solid
Long flash
Short flash
Off
Cause
Charger unable to apply wake-up
pulse
Charge timeout
BMS fault
Charger shutdown due to high
internal temperature.
Internal charger fault
www.delta-q.com
Delta-Q QuiQ Charger Manual
(Orange
Light)
(Green
Light)
(Orange
Light)
(Red
Light)
Indication
Charge complete
Greater than 80% state of charge
Less than 80% state of charge
See charger for indications.
Solution
Refer cart to service department
Possible BMS error - refer cart to service department
Refer cart to service department
Ensure sufficient cooling airflow. Reset the charger
by interrupting AC power for 15+ seconds.
Reset the charger by interrupting AC power for 15+
seconds. Return to service department if fault persists.
2
Advertisement
