Table of Contents
Advertisement
Precautions for installation
Panasonic assumes no responsibility for injuries or property damage resulting from
failures arising out of improper installation or operation inconsistent with this
documentation.
For information about the installation tasks, refer to the provided Installation Guide.
In order to prevent injury, the product
must be securely mounted to a wall or
ceiling according to Installation Guide.
Installation place
<WV-X6531NS (Heavy salt damage resis-
tance) only>
The camera has heavy salt damage resistance
treatment applied, but this does not ensure
complete resistance against corrosion. Please
pay attention to the installation location such as
in places where seawater does not splash
directly.
Especially when installing this product in coastal
areas and area that are sprayed with snow-melt-
ing agent that are not exposed to rainwater, peri-
odically clean by rinsing to remove adhered salt.
Periodically inspect the camera when installing it
in coastal areas or areas that are sprayed with
snow-melting agent. (Replace parts as neces-
sary.)
Prepare the foundation of the installation site,
installation support, and any other installation
setting with heavy salt damage resistance treat-
ment.
<WV-X6531N / WV-X6511N / WV-S6530N>
The product can not be installed in areas by
the sea, the seashore, or where snow-melting
agent is sprayed.
Power supply
This product has no power switch.
When performing electrical work, make sure the
camera can be turned on and off. When an
Ethernet cable or power cable is connected, the
power is turned on. When the product is sup-
plied, the product will perform panning, tilting,
zooming and focusing.
When cleaning the product, remove the Ethernet
cable or disconnect the power cable from the
main power supply.
Installation area for this product
Select an appropriate place for the installation
area (such as a strong wall or ceiling) in your
particular environment.
• When hanging the camera from a ceiling,
use the WV-Q121B / WV-Q121BS (Heavy
salt damage resistance) (option) ceiling
mount bracket.
• When installing on a wall, use wall mount
bracket WV-Q122A / WV-Q122AS (Heavy
salt damage resistance) (option).
• When pendant-mounting on a ceiling on a
bracket that is custom-made, use the
attachment pipe. <WV-X6531N /
WV-X6511N / WV-S6530N only>
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• Do not mount the product on a plaster
board or a wooden section because they
are too weak. If the product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
When using the camera in combination
with an attachment pipe and attaching to
a locally procured bracket <WV-X6531N /
WV-X6511N / WV-S6530N only>
• Locally procure a M6 eye bolt (stainless
steel).
Recommended tightening torque:
2.45 N·m {1.8 lbf·ft}
• In order to prevent the camera from falling,
procure a bracket that can be attached a
safety wire.
• Connect the M6 eye bolt and locally pro-
cured bracket together with the safety wire.
14
Advertisement
Table of Contents
