Split Large Logs, Operation Tips - Boss Industrial 3PT16T21 Assembly & Operating Instructions

Dual-action 3-point hitch 16 ton log splitter
Table of Contents

Advertisement

WARNING! Never place a hand on the ends of the log, between the log and the end plate or
the log and the splitting wedge.
WARNING! Only one operator permitted. The adult who loads and stabilizes the log, must be
the person who operates the control handle.
WARNING! Never remove partially split wood from the wedge with your hands. Fingers may
become trapped between the split wood.
.
SPLIT LARGE LOGS
When splitting a large log, or one in which the wood is extremely tough or stringy(such as elm), , the first pass through the
Splitter may not split the log into two sections. If this happens, turn the log and split off small sections. Repeat this process
as necessary to split the entire log.
OPERATION TIPS
Always:
1
Follow the Checklist below each time you use your log splitter for optimum performance.
[ ] Check the general condition of the log splitters, e.g.: bolts, nuts, welds, clamps, hoses, etc.
[ ] Check hydraulic level in your tractor and fill as needed.
[ ] Check hydraulic hoses for cracks or wear.
[ ] Check the frame for stability.
[ ] Check the wedge for tightness, nicks and wear.
2. Bleed the air out of the hoses before operating.
3. Be alert and turn the Tractor off if children or pets enter the work area.
4.
Use "pipe dope" on all hydraulic fittings.
5.
Split wood along the grain (lengthwise) only.
Never:
1. Use when fluid is below 20° F or above 150° F.
2. Operate through relief valve for more than 5 seconds.
4. Attempt to adjust the unloading or relief valve settings.
5. Operate with air in hydraulic system.
6. Attempt to cut wood across the grain.
7. Attempt to remove partially split wood from the wedge with your hands. Use a hammer to knock it off.
8. Never allow children to operate the log splitter.
Page 16
OPERATION INSTRUCTIONS
Page 19

Advertisement

Table of Contents
loading

Table of Contents