Jet Motor 7762
The following thermal pads are approved for use:
Eapus XR-PE
1. Remove all traces of thermal grease from CPU using a lint-free cloth or cotton swab
and Isopropyl Alcohol, Acetone, or other approved cleaning agent.
2. Apply small amount of thermal grease to center of CPU.
NOTE:
NOTE:
Force used during installation of thermal module is sufficient to spread grease
evenly over CPU top.
3. Place Thermal Module on Mainboard. Refer to
4. Tighten three (3) captive screws (A) in numerical order from one (1) to three (3) to
mainboard
(Figure
5. Connect thermal module cable to mainboard connector (B)
6. Install Mainboard.
Machine Maintenance Procedures
3-23). Ensure the thermal module is properly aligned and seated.
Figure
3-23.
(Figure
3-23).
3-27