Finish In; I-Dos Settings - Siemens WM16Y892AU Instruction Manual And Installation Instructions

Setting 0: No spin cycles, the water is
only drained. The laundry stays wet
inside the drum, e.g. for items that
should not be spun.

Finish in

The programme duration is shown after
selecting the programme.
Before starting the programme, you
can preselect the programme end in
hourly increments (h = hour) up to a
maximum of 24 hours.
After starting the programme, the
selected number of hours e.g. 8 h is
shown on the display panel and counts
down until the wash programme starts.
The duration of the programme is then
displayed.
The programme duration is
Note:
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings, options, foam
detection function, unbalanced load
detection, the load or soiling may also
change the programme duration.
After starting the programme , you can
change the preselected number of
hours as follows:
Press the Ü button.
1.
Use the Finish in button to change
2.
the number of hours.
Press the Ü button.
3.
After starting the programme, while the
programme is running, you can add or
remove laundry if necessary.
~ Page 29

i-Dos settings

Your washing machine has an intelligent
dosing system for liquid detergent and
fabric softener (or detergent when using
the setting Dispenser content:
Detergent ~ Page 35)
Programme default settings
For the majority of programmes on your
washing machine, detergent and fabric
softener are dosed automatically.
The i-Dos settings are not retained when
the appliance is switched off.
The following have been preset at the
factory:
i-Dos ô : ¨
■
Detergent dosage for lightly soiled
laundry
i-Dos iIô : ©
■
Fabric softener dosage for a
medium level of softness
i-Dos ô for detergent
Dosage strengths
High: heavy soiling and staining
ª
Medium: average soiling
©
Low: light soiling
¨
Automatic dosage deselected,
ö
manual dosage ~ Page 34
You can change the settings for
automatic detergent dosage before the
programme starts. You can find
information on degrees of soiling on
~ Page 15
i-Dos i for fabric softener
Dosage strengths
High: high level of softness
ª
Medium: medium level of softness
©
Low: low level of softness
¨
Automatic dosage deselected
ö
Depending on what stage the
programme is in, you can change the
settings for automatic detergent
dosage.
en
23