Table of Contents
Advertisement
08 Setting the Admin Menu
To access the Admin menu, press the
following buttons on the remote control:
1. Press the MUTE button.
2. Press the 1 button.
3. Press the 1 button.
4. Press the 9 button.
5. Press the SelectE button.
To control the TV functions in the Admin menu, the TV has two modes, the Standalone mode and the Interactive mode.
The menu items that differ between the modes are listed below.
Menu items in the Standalone mode only:
• SI Vendor: OFF / Movielink / Swisscom / SSCP
• LYNK Cloud, LYNK HMS, Virtual Standby, Room Number and its submenus.
Menu items in the Interactive mode only:
• SI Vendor: Samsung and other vendors.
All other items appear in both modes.
After a menu appears, follow these general directions to navigate and change values:
• Use the directional buttons on the remote control to move from menu item to menu item.
• Press the Select button on the remote control to select a menu item. The screen displays that menu item only.
• Press the left or right directional button to change a value. The right directional button increases numerical values.
The left arrow button decreases numerical values.
• When the screen is displaying one menu item, you can press the up or down directional button to display the next
or previous menu item.
• Press the RETURN button to exit the current menu item and go to a higher menu level.
• To exit a Admin menu, turn off the TV, and then turn it on again. Any changes you made are saved except changes
to SI (System Integration) vendor. For changes to SI vendor, you must turn the TV off, wait until the power indicator
at the bottom of the TV glows steadily. And then unplug the TV's power cord, wait for the power indicator to go off,
and then plug the TV's power cord in again.
To change menus between the Interactive mode and the Standalone mode, follow the steps below:
1. Highlight the Hospitality Mode menu item in the top left corner of the menu.
2. Press the Select button on the remote control. Only the Hospitality Mode menu item is displayed.
3. Press the left or right directional button to change the Hospitality Mode item from Standalone to Interactive or
from Interactive to Standalone.
4. Press the RETURN button on the remote control. The entire menu re-appears with your selection displayed in the
Hospitality Mode item.
– After you have set the values in one TV, you can clone those values to multiple TVs.
– For more information about the USB cloning refer to page 30.
English - 23
Advertisement
Table of Contents
