Installation
3.3. Electrical connection
Connect the product to a grounded outlet
protected by a fuse complying with the values in
the rating plate. Our company shall not be liable
for any damages that will arise when the product
is used without grounding in accordance with the
local regulations.
•Electrical connection must comply with national
regulations.
•Power cable plug must be within easy reach after
installation.
•The voltage and allowed fuse or breaker
protection are specified in the Rating Plate which
is affixed to interior of the product. If the current
value of the fuse or breaker in the house does not
comply with the value in the rating plate, have a
qualified electrician install a suitable fuse.
•The specified voltage must be equal to your
mains voltage.
•Do not make connections via extension cables or
multi-plugs.
WARNING:
B
cable must be replaced by the
Authorised
Damaged power
Service Agents.
8 /32 EN
WARNING:
has a failure, it should not be
B
operated unless it is repaired by
Authorised
the
There is the risk of electric
shock!
3.4. Adjusting the feet
If the product stands unbalanced after installation
adjust the feet. Taking help from someone to
slightly lift the refrigerator will facilitate this
process.
WARNING:
product. Product must not be
B
plugged in when adjusting the
feet. There is the risk of electric
shock!
Turn the front feet to balance the product. The
corner where the foot exists is lowered when you
turn in the direction of arrow and raised when you
turn it in the opposite direction.
In order to adjust the doors vertically,
•Loosen the fixing nut at the bottom
•Screw adjusting nut (CW/CCW) according to the
position of the door
•Tighten the fixing nut for the final position
In order to adjust the doors horizontally,
• Loosen the fixing bolt on the top
• Screw the adjusting bolt (CW/CCW) on the side
according to the position of the door
• Tighten the fixing bolt on the top for the final
position
If the product
Service Agent!
First unplug the
Refrigerator / User Manual