Craftsman CMCG400 Instruction Manual page 14

English
To remove the battery pack from the tool, press the release
button 2 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
2
Fig. G
1
Proper Hand Position (Fig. A, H)

WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the auxiliary
handle 7 , with the other hand on the body of the tool.
Fig. H
Lock-Off Button and Trigger Switch
(Fig. I–K)
Your grinder is equipped with a lock-off button
• To lock the trigger switch
11 to the rear as shown in Figure I. When the lock-off
button is moved to this position, the trigger switch
is locked.
nOTE: Always lock the trigger switch when carrying or
storing the tool to eliminate unintentional starting.
12
11 .
10 , move the lock-off button
Fig. I
• To unlock the trigger switch, move the lock-off button
to the front. When the lock-off button is moved to this
position, the trigger switch is unlocked.
Fig. .J
• Pull the trigger switch
10
Releasing the trigger switch turns the motor OFF.
Fig. K
10
nOTE: This tool has no provision to lock the switch in
the ON position, and should never be locked ON by any
other means.
Hold the three position auxiliary handle
tool firmly to maintain control of the tool at start up and
during use and until the wheel or accessory stops rotating.
11
11
to turn the motor ON.
and body of the
7