Table of Contents
Advertisement
Before the 1st washing
The washing machine was inspected thoroughly before leaving
the factory. To remove any water left over from testing
procedures, the first washing cycle should be carried out without
laundry in the machine.
²
The washing machine must have been installed and connected
properly. See chapter Installing ~ Page 64
Check the machine.
1.
²
Never switch on a damaged machine. Inform your customer
service. ~ Page 51
Fill dispensers
2.
Remove protective film from the fascia.
3.
Insert mains plug.
4.
Turn the tap on.
5.
Switch on the appliance.
6.
Close the washing machine door. Do not load any washing.
7.
To prevent unused detergent from flowing into the outlet
8.
during the first wash: Pour 1 litre of water into dispenser
and start the Drain programme.
Select and start the Cottons 90 °C programme.
9.
When the programme ends, switch off the appliance.
10.
Your washing machine is now ready for use.
M w
. ~ Page 33
w
/
u v
67
Advertisement
Table of Contents
