Important Safety Instructions; Symbols Used In These Instructions - Igema NA7-45 Installation And Operating Instruction

1. Important safety instructions

KEEP THESE INSTALLATION AND OPERATING INSTRUCTIONS IN A SAFE PLACE!
Commissioning as well as maintenance and repair work may only be carried out by qualified
persons in compliance with the installation instructions given in this operating manual. The
correct installation, commissioning, maintenance and operation of the device presupposes that
the person in charge is familiar with measurement and control systems and complies with the
general installation and safety instructions. In addition, the correct and intended use of tools
and the handling of safety devices must be ensured. Unqualified persons must not be assigned
the above tasks!
IGEMA GmbH accepts no liability for damage to property or personal injury caused by
unqualified persons or by failure to observe these installation and operating instructions. If no
sufficiently qualified person can be found, IGEMA GmbH can be commissioned with the
installation/maintenance.

1.1 Symbols used in these instructions

In the following installation and operating instructions, safety instructions are marked with the
following symbols:
Danger
Caution electrical voltage
Caution hot
6
This symbol and signal word refer to a potentially
hazardous situation which could result in death or
injuries if ignored.
This symbol and signal word indicate live parts
with an immediate danger of death from electric
shock.
This symbol with a signal word indicates a
potentially hazardous situation that can result in
severe burns and scalds all over the body.