For Safe Operation - Omega Mugello 2525 User Manual

1. FOR SAFE OPERATION

1. Never operate a saw when you
are fatigued, ill, or upset, or under
the influence of medication that
may make you drowsy, or if you
are under the influence of alcohol
or drugs.
2. Use safety footwear, snug fitting
clothing and eye, hearing and
head protection devices.
3. Always use caution when hand-
ling fuel. Wipe up all spills and then
move the chain saw at least 3m from
the fueling point before starting the
engine. Eliminate all sources of sparks
or flame (i.e. smoking, open flames,
or work that can cause sparks) in the
areas where fuel is mixed, poured, or
stored. Do not smoke while handling
fuel or while operating the chain saw.
4. Do not allow other persons to be
near the chain saw when starting or
cutting. Keep bystanders should be
a minimum of 10m away when you
start of operate the chain saw.
5. Never start cutting until you have
a clear work area, secure footing,
and a planned retreat path from the
falling tree.
6. Always hold the chain saw firmly
with both hands when the engine is
running. Use a firm grip with thumb
and fingers encircling the chain saw
handles.
7. Keep all parts of your body away
from the saw chain when the engine
is running.
8. Before you start the engine, make
sure the saw chain is not contacting
anything.
9. Always carry the chain saw with
the engine stopped, the guide bar and
saw chain to the rear, and the muffler
away from your body.
10. Always inspect the chain saw
before each use for worn, loose, of
damaged parts. Never operate a chain
saw that is damaged, im- properly
adjusted, or is not com- pletely and
securely assembled. Be sure that the
saw chain stops moving when the
throttle control trigger is released.
11. All chain saw service, other
than the items listed in the Owner's
Manual, should be performed by com-
petent chain saw service personnel.
(E.g., if improper tools are used to re-
move the flywheel, or if an improper
tool is used to hold the flywheel in
order to remove the clutch, structural
damage to the flywheel in order to
remove the clutch, structural damage
to the flywheel could occur which
could subsequently cause the flywhe-
el to disintegrate).
3 3
EN