Displaying And Setting The Water Hardness - Miele G6620SC Operating Instructions Manual

Before using for the first time
Displaying and setting the water
hardness
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the Start button in and whilst
holding it in switch the dishwasher
on using the  button.
Keep the Start button pressed in for
at least four seconds until the Start
indicator light comes on.
If this does not happen, start the pro-
cedure from the beginning again.
 Press the  button twice.
The  indicator will flash rapidly twice
at intervals.
20
The value set for the water hardness is
shown as a figure after  in the display
(see chart).
   will start flashing in the display.
This is the factory default setting of
15°d.
 Use the Start button to select the
value which equates to your water
hardness level.
Each press on the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
The setting is now stored in memory.
 Switch the dishwasher off with the 
button.