Cutting The Leading Edge Of Roll Paper Automatically - Canon TM-5300 Online Manual

Cutting the Leading Edge of Roll Paper Automatically

If the leading edge of the paper is cut crooked or is not cut straight when roll paper is loaded, it will not print
correctly. If this happens, you can cut the leading edge of the paper straight when loading a paper roll by
using Trim edge first in the operation panel menu.
The following settings are available for Trim edge first.
• Auto
If the leading edge of the paper is cut crooked and is not cut straight when loading roll paper, cut the
leading edge straight and eject the fragment of paper to prevent printing on the platen and soiling the
printer.
• On(Preset Length)
The amount to cut from the leading edge of the paper varies depending on the media type and is cut to
a prescribed length. For the leading edge precut length, see "Paper Information List".
• On(Input Length)
The amount to cut from the leading edge of paper is specified in the control panel. The amount to cut
from the leading edge can be specified in the range of lengths displayed in the control panel. The range
of lengths differs according to the media type.
Note
• The amount to cut from the leading edge of paper cannot be set shorter than the length displayed in
the control panel.
• Manual
The amount to cut from the leading edge of paper can be adjusted by using the operation panel.
To cut the paper after adjusting, tap Cut paper and select Yes.
After cutting the paper, tap Complete paper loading.
Note
• If you do not tap Complete paper loading after cutting the paper, you cannot print the next job.
• Off
The edge is not cut and scraps are not removed.
Follow these steps to change the Trim edge first setting.
1. Tap paper settings display area on Home screen of operation panel.
82