Table of Contents
Advertisement
g. After about 2 seconds, the comments are changed again as follows.
<1>Connect : "Connect E:" -> "N/A"
<2>Set Area : "Success" -> "N/A"
NOTE:
If the Initial Setting is executing, the setting item of DSC returns to the state of the shipment.
-"<2>SetArea, SN" button is not use in panasonic service.
-"AUTO ADD ONE" function is not use in panasonic service.
Step 3.Confirmation :
a. Close the "PcAppSample.exe" by clicking on the "Cancel" located on the top right corner.
b. Turn off the camera switch.
c. Disconnect the USB cable.
d. Confirm that the language and Clock set request screen is displayed on the LCD monitor. Major default setting condition is as
shown in the following table.
10
Advertisement
Table of Contents
