Table of Contents
Advertisement
Saturation display
When the metal grease filter or activated charcoal filter is
saturated, the corresponding button flashes or lights up:
Metal grease filter: The
■
Metal grease filter and activated charcoal filter:
■
The
y
button flashes.
When this happens, clean the metal grease filters or replace
the activated charcoal filters as soon as possible; see the
Cleaning and maintenance section.
Resetting the saturation displays
Switch off the motor and the lighting.
1.
Press and hold the
button.
H
2.
The
button flashes 3 times. The saturation indicator for the
#
metal grease filter and for the activated charcoal filter is reset.
Switching over the display for circulating-air mode
For air recirculation, the electronic control display must be
switched over accordingly:
Check whether the extractor hood is connected and switched
1.
off.
Press and hold the 3 button until the
2.
The electronic control is switched over to air recirculation.
Switching over the display for exhaust air mode
Check whether the extractor hood is connected and switched
1.
off.
Press the 3 button until the
2.
The electronic control is switched over to air extraction.
Cleaning and maintenance
:
Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Risk of electric shock!
Penetrating moisture may result in an electric shock. Clean the
appliance using a damp cloth only. Before cleaning, pull out the
mains plug or switch off the circuit breaker in the fuse box.
:
Risk of electric shock!
Do not use any high-pressure cleaners or steam cleaners,
which can result in an electric shock.
:
Risk of injury!
Components inside the appliance may have sharp edges. Wear
protective gloves.
Cleaning agents
Observe the information in the table to ensure that the different
surfaces are not damaged by using the wrong type of cleaning
agent. Do not use
harsh or abrasive cleaning agents,
■
cleaning agents with a high concentration of alcohol,
■
hard scouring pads or sponges,
■
high-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the cleaning
agents.
8
H
button lights up.
button flashes twice.
#
button flashes once.
#
Cleaning protection
The appliance is equipped with a cleaning protection function.
When this function is activated, the control panel can be
cleaned without changing the settings.
Switching on
Press the
button to switch off the fan.
#
1.
Press and hold the 2 button.
2.
All of the control panel buttons flash twice at the same time,
and then flash one after another. Cleaning protection is
switched on.
Switching off
Press and hold the 2 button until the buttons on the control
panel stop flashing.
Cleaning protection is switched off.
Area
Cleaning agents
Stainless steel
Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth.
Clean stainless steel surfaces in the
direction of the grain only.
Special stainless steel cleaning products
are available from our after-sales service
or from specialist retailers. Apply a very
thin layer of the cleaning product with a
soft cloth.
Painted surfaces
Hot soapy water:
Clean using a damp dish cloth and dry
with a soft cloth/towel.
Do not use any stainless steel cleaners.
Aluminium and
Glass cleaner:
plastic
Clean with a soft cloth.
Glass
Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Operating controls
Hot soapy water:
Clean using a damp dish cloth and dry
with a soft cloth.
Risk of damage to the electronics from
penetrating moisture. Never clean
operator controls with a wet cloth.
Do not use any stainless steel cleaners.
Advertisement
Table of Contents
