Suzuki 2009 SX4 SEDAN Owner's Manual page 160

Engine Block Heater: 1
OPERATING YOUR VEHICLE
Vehicle With Keyless Start System
The ignition switch can be operated with-
out using an ignition key when the remote
controller is in an area of the vehicle other
than the rear luggage area. To turn the
ignition switch, first push in the switch.
• Manual transaxle vehicle
You must push in the ignition switch to
turn it from the "LOCK" position to the
"ACC" position. To return to the "LOCK"
position from the "ACC" position, turn the
ignition switch counterclockwise while
pushing in the switch.
• Automatic transaxle vehicle
To turn the ignition switch, push the
switch.
6-3
EXAMPLE
80JC002
If the keyless start system blue indicator
light illuminates on the instrument cluster,
you can turn the ignition switch. If the red
indicator light illuminates, you can not turn
the ignition switch.
NOTE:
• The ignition switch can be turned to the
"ACC" position when the keyless start
system blue indicator light illuminates.
The blue indicator light will illuminate for
several seconds when you push in the
ignition switch and then will turn off to
protect the system. In this case, you
must release the ignition switch and
push it again to illuminate the blue indi-
cator light.
• If the keyless start system red indicator
light illuminates, the remote controller
may not be in the vehicle or the battery
of the remote controller may be unreli-
able.
NOTE:
• If the battery of the remote controller
runs down or there are strong radio
waves or noise, the operating range may
be narrower or the remote controller may
be inoperative.
• If the remote controller is too close to the
door glass, it may not operate.
• The ignition switch may not turn when
the remote controller is on the instru-
ment panel, in the glove box, in a stor-
age compartment, in the sun visor or on
80J037
the floor.
CAUTION
The remote controller is a sensitive
electronic instrument. To avoid dam-
aging it, do not expose it to impacts,
moisture or high temperature (such
as on the dashboard under direct
sunlight).
You can also turn the ignition switch by
inserting the ignition key into the slot.
If you leave any of the doors open with the
ignition switch in the "ACC" position for a
while (and no key inserted), the engine
may not start when you turn the ignition
switch to "START". If the engine does not
start, close all doors completely or turn the
ignition switch back to the "LOCK" position,
then start the engine.
80J22-03E