Download Print this page

MICRO-AIR EasyStart 364 Relearning

Hide thumbs Also See for EasyStart 364:

Rev 1.00

NOTE: Power should always be turned off

when working with electrical components

Relearning EasyStart – 364

1. Remove the cover and find the jumper (JP1)

Please note that you will need to move the

black start capacitor slightly to fully expose the jumper pins.

Table of Contents

Need help?

Do you have a question about the EasyStart 364 and is the answer not in the manual?

Page 1 Rev 1.00 NOTE: Power should always be turned off when working with electrical components Relearning EasyStart – 364 1. Remove the cover and find the jumper (JP1) Please note that you will need to move the black start capacitor slightly to fully expose the jumper pins.
Page 2 Rev 1.00 NOTE: Power should always be turned off when working with electrical components 2. Move the jumper block from the Factory Default to the Relearn position as shown in the below examples. We recommend using a pair of needle nose plyers or tweezers. 3.