Page 2
Your drinking water is going to be healthier and taste better from now on, and nothing makes us happier. Getting RO Faucet started is a breeze - most of your Elite RO is already assembled and every connection is color coded. We’ve marked where the colored tubes will go with matching colored plugs in each fitting.
General This Elite RO unit is for climate controlled indoor use only. Exposure to overly high or low temperature ranges will damage the unit. Follow all of your state and local laws and codes regarding plumbing even if they differ from what is stated in this manual.
Monday - Friday 10am to 5pm PST Replacements Table Your new Elite RO should include the following items. If any item is missing please contact Express Water. Please take a few moments to check all the following components: Accessories and Connections Color Coded Tube 1/4”...
Tubing must be perfectly straight. Connector NOTE! Improperly cut Tubing may leak water or fail to lock into Fittings. Wait until all elements of your Elite RO are in their final locations before cutting your Tubing. Closed Open 1/4” Blue Color Tube Make sure you measure the length you will need before cutting.
During installation leave your Feed Water Adapter Valve in the “CLOSED” position until System Startup. The Feed Wa- ter Adapter Valve controls all water coming into your Elite RO. If for any reason you need to stop incoming water turn the Feed Water Adapter Valve to the “CLOSED”...
To avoid clogging the drain line with debris do not install the Drain Saddle after the drain pipe meets a garbage disposal or dishwasher drain. Refer to the image below to see ideal Drain Saddle locations. 1. Position the Elite RO in the desired Position the Leak Stop Valve on the floor permanent location.
(6-9 hours). on page 16. NOTE! If the Elite RO is connected to a refrigerator do not drain the system through the refrigerator water OPEN POSITION CLOSED POSITION dispenser. The excess carbon fines from the new carbon filter will clog the internal fridge filter.
When you plan to not use your Elite RO for 2 weeks or more the Feed Water should be Turned Off to prevent exposure to water pressure fluctuations. Locate the red Feed Water Adapter Valve connected to your Cold Water Supply (refer to page 11).
Bubbles in your water is a common issue, but they only affect the appearance of your water and This warranty covers any defects in the parts or manufacturing of your Express Water Elite RO. We will give you new replacement parts in exchange for any defective parts.
Page 11
Express Water Inc. 12730 Raymer St, Unit 1, North Hollywood, CA 91605 1-800-992-8876 • support@expresswater.com • www.expresswater.com...
Need help?
Do you have a question about the ELITE RO and is the answer not in the manual?
Questions and answers