Information About The Batteries - Hoover H84-7WD-ZA Instructions And Warranty

Wet & dry handheld vacuum
Table of Contents

Advertisement

INFORMATION ABOUT THE BATTERIES

1. This hand vacuum cleaner is operated by rechargeable Lithium batteries.
Before using the cordless hand vacuum cleaner for the first time, the batteries must
be charged for at least 12 hours.
2. The batteries reach their full capacity after a charging period of 6 hours. For care
of the batteries we recommend the following: after the batteries are charged, remove
the power adapter 4 from the mains power socket. Reconnect the power adapter 4
again with the mains power socket when the suction power of the appliance is
noticeably weaker.
INSTALLATION OF THE WALL MOUNT
Extreme Caution Required!
Ensure that there are no power cables or other conduits or pipes in the wall at the
location where you intend to drill the holes for the wall mount (3). It would be a
potentially fatal risk to drill into a current carrying electric cable!
1. Place the power cord (5) of the power adapter (4) into the wall mount (3) as shown
in the diagram.
Secure the power cord (5) by turning it.
2. Select a suitable installation location for the wall mount (3): It should present no
problem when removing the vacuum cleaner and the power socket for the power
adapter (4) must be accessible.
3. Drill two holes with a spacing of approx. 58mm between the holes. Use the wall
mount (3) to mark the holes: this will ensure the spacing is correct. The holes must
be suitable for 5mm wall plugs.
4. Insert the wall plugs into the holes and, using the screws, firmly screw the wall
mount (3) to the wall.
5. Place the nozzles on the lateral accessories holder.
6. Connect the power adapter (4) to a mains power socket.
CHARGING
Note:
Check to ensure that the on/off switch (6) has been slid back (to the position "0")
before starting the charging process.
• Place the hand vacuum cleaner from above into the wall mount (3) so that the
power cord (5) slips into the socket on the hand vacuum cleaner.
The charging indicator light (7) glows blinking RED and the charging process begins.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents