Download Print this page

Cleaning And Care - komodo KD2PCINFKYA User Manual

1-2 person inflatable cruising kayak

Advertisement

CLEANING & CARE
• Remove oars/paddles and other accessories.
• To deflate, unscrew the valves' insert. Remove the fin.
• Clean and check the kayak as well as all the accessories after each use. Rinse it
thoroughly making sure to remove any residues of salt if used in salt water.
• Use a mild soapy solution, do not use detergents or any type of silicone-based
products. Make sure the product is completely dry before putting it away.
• Fold the 2 sides into the middle, then roll it up from the opposite end of the valves (so
remaining air can escape from the valves); start again if you feel there is still some air in
the tubes.
• When storing your inflatable, keep it in a clean and dry place that is not affected from
major variations in temperature and other damaging factors. You may store it deflated
and rolled up in the carry bag or assembled and lightly inflated (make sure you do not
subject it to deformations).
Repair
WARNING: Tears or holes detected on sealing strips are not reparable
by the kit delivered. Cease use immediately and contact
help.Kogan.com for support.
How to repair small punctures:
• You can repair small punctures with the included repair kit. Please note that in order for
the repair to be successful, the humidity level should be less than 60%, temperature
between 18°C-25° C. Avoid carrying out repairs in the rain or in direct sunlight.
• To remove the inside bladder(s) please open the zippers on the inside of the kayak
cover; each air chamber features a zipper at the bow and a zipper at the stern of the
kayak for quick and easy access. Check that the tube is fully deflated and lies flat.
1.
Draw the shape of the patch exactly where it will be applied, cut a round patch at
least 2-5 cm larger than the cut/damaged area.
2.
Clean the damaged area and the corresponding side of the patch with a grease
remover of the alcohol type and allow for it to dry for 5 minutes.
3.
Apply 3 thin layers of glue on both the patch and the damaged area, allow for it to
dry for 5 minutes between layers until the glue feels tacky

Advertisement

loading