Ebyte E78-470LN22S User Manual page 30

Chengdu Ebyte Electronic Technology Co.,Ltd.
Parameter
Description
Return value
description
Example
Precautions
Command Command
character Type
Test
command
Setting
command
Parameter
Description
IREBOOT
Return value
(Restart module)
description
Example
Precautions
Command Command
character Type
Test
command
Setting
command
Parameter
Description
CLPM
Return value
(Enable low
description
power
Example
consumption)
Precautions
Command Command
character Type
ECHO Query
Copyright ©2012–2021，Chengdu Ebyte Electronic Technology Co.,Ltd.
This command restores the MAC default configuration parameters to
EERPOM/FLASH.
AT+CRESTORE=
OK
Command Format
AT+IREBOOT=?
AT+IREBOOT=<mode>
<mode>: restart mode;
0: Restart the communication module immediately.
1: Wait for the radio frame currently being sent in the communication
module to complete and then restart.
AT+IREBOOT=1
OK
After receiving the instruction, the communication module will reply to OK
and restart the communication module. No further AT commands are
received until the restart is complete.
Command Format
AT+CLPM=?
AT+CLPM=<mode>
<mode>: Low power mode
1: The device enters low power consumption
AT+CLPM=1
OK
After entering low power consumption, send the serial port command again
to wake up;
Because the UART start part byte may be transmitted incorrectly when
transmitting above 40kbps, AT+CLPM=0 may be recognized as an error
and return "+CME ERROR". It is recommended to use "000000000D0A"
(hexadecimal) for wakeup.
Command Format
AT+ECHO?
E78-470LN22S User Manual
response
+IREBOOT:"Mode"
OK
OK
response
+CLPM:"Mode"
OK
OK
response
+ ECHO:"Mode"
29