ZyXEL Communications C3000Z Quick Start Manual page 5

1. Use a telephone cable to connect your Device's DSL port to a
telephone jack (or the DSL or modem jack on a splitter if you have
one).
2. ETHERNET: Use an Ethernet cable to connect a computer to a LAN
port for initial configuration and/or Internet access.
3. USB: You can connect a USB memory stick or a USB hard drive for
file sharing. The Device automatically detects the USB device.
Alternatively, use a USB cable (not provided) to connect a USB
printer to this port.
4. POWER: Use the provided power adaptor to connect the POWER
socket to an appropriate power source. Make sure the power at the
outlet is on. Look at the lights on the front panel.
• The POWER light blinks while your Device starts up and then stays
solid green once it is ready.
• The DSL lights are solid green after your Device has a DSL
connection.
• The INTERNET light turns on when the Device is able to access the
Internet and blinks when the Device is sending or receiving data.
• The WAN/LAN light is on if the WAN/LAN port is properly connected
and blinks when there is traffic.
• Each ETHERNET light is on if the corresponding LAN port is
properly connected and blinks when there is traffic.
• The USB light turns on when there is a USB printer or memory
device is connected to the Device and blinks when transmitting data.
• The WiFi 2.4G light is green when the wireless LAN is ready and
blinks when there is traffic.
• The WiFi 5G light is green when the wireless LAN is ready and
blinks when there is traffic.
• The WPS light is green when WPS is enabled and blinks amber
while WPS is in process.

If the lights do not come on, check your connections and inspect your cables
for damage. If the lights are still off, contact technical support.
5