This Appliance Must Be Earthed; Fitting A Different Plug; Initial Use - Beko DIS15012 User Manual

Installation
A
This appliance must
be earthed
If the fitted moulded plug is not
suitable for your socket, then
the plug should be cut off and
an appropriate plug fitted.
Destroy the old plug, which is
cut off as a plug with a bared
cord could cause a shock
hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this
appliance incorporates a 13A
fuse. Should the fuse need to
be replaced an ASTA approved
BS1362 fuse of the same rating
must be used. Do not forget
to refit the fuse cover. In the
event of losing the fuse cover,
the plug must not be used
until a replacement fuse cover
has been fitted. Colour of the
replacement fuse cover must be
the same colour as that visible
on the pin face of the plug. Fuse
covers are available from any
good electrical store.

Fitting a different plug

As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals on your plug, proceed as follows:
1. Connect the green - yellow or green
(earth) wire to the terminal in the plug
marked 'E' or with the symbol
coloured green and yellow or green.
2. Connect the blue (neutral) wire to
the terminal in the plug marked 'N' or
coloured black.
3. Connect the brown (live) wire to the
terminal in the plug marked 'L' or
coloured red.
Dishwasher / User's Manual
Green and yellow
N
Blue or
black
With the alternative plugs a 13A fuse must
be fitted either in the plug or adaptor or
in the main fuse box. If in doubt contact a
qualified electrician.

Initial use

Before starting to use the product, make
sure that all preparations are made in
accordance with the instructions in sections
"Important safety instructions" and
"Installation".
Before using the product, fill the salt
•
reservoir with 1 litre of water, add salt
(see next page) and stir to dissolve.
Run the Dishwasher without dishes
on a short programme with a small
amount of detergent.
A
There might be a small amount
of water left in the product after
or
factory quality control tests. This
causes no harm to the product.
or green
Brown or red
11 / 41 EN
L