Table of Contents
Advertisement
Water cooling accessories installation
This section describes from installing tubeing on the north bridge water block to the
adapters. A complete water-cooling system consists of waterblock, tubing, pump,
radiator and reservoir. To complete the water-cooling system safely you have to
purchase separate pumps, radiators and reservoirs etc.. Please read carefully the
installation manual provided by the water-cooling manufacturer.
Follow the steps below to install the accessories.
Before you start, you need to prepare a pair of pliers.
1. Slide the C type tubing clip in to the groove of the heat sink and the angle as shown
below figure. W hen the clip slide into the hole position, turn it to 90 degrees. Use
the same way to ins tall another clip, as shown in the figure below af ter the
completion.
2. Use pliers to remove the two rubber caps from the north bride waterblock.
Hardware Setup
2-29
Advertisement
Table of Contents
