Pontiac 2003 Sunfire Owner's Manual page 152

Finding a Station Setting Preset Stations
BAND: Press this button to switch between AM, FMI,
FM2, or XMI, XM2 (USA only, if equipped). The
display will show your selection.
TUNE: Turn this knob to choose
,radjo,
~tatjons~.
A
SEEK
v
: Press the up or the down arrow to go to
the next or to the previous station and stay there.
The radio will seek only to stations that are in the
selected band and only to those with a strong signal.
SCAN
v
: Press and hold one of the SCAN arrows
for two seconds until SCAN appears on the display
and you hear a beep. The radio will go to a station, play
for a few seconds, then go on to the next station.
Press one of the SCAN arrows again to stop scanning.
To scan preset stations, press and hold one of the
SCAN arrows for more than four seconds until PSCAN
and the preset number appear on the dlsplay. You
will hear a double beep. The radio will go to the first
preset station stored on your pushbuttons, play for a few
seconds, then go on to the pext preset station. Press
one of the SCAN arrows again to stop scanning presets.
The six numbered pushbuttons let you return to your
favorite stations. You can set up to
30
stations (six AM,
six FMI and six FM2, six XM1 and six XM2 (USA
only, if equipped), by performing the following steps:
1. Turn the radio on.
2. Press BAND to select AM, FMl, FM2, or XMI, or
3. Tune in the desired station.
4. Press EQ to select the equalization.
5. Press and hold one of the six numbered
XM2.
pushbuttons until you hear a beep. Whenever you
press that numbered pushbutton, the station
you set will return and the equalization that you
selected will also be automatically selected for that
pushbutton.
6. Repeat the steps for each pushbutton.
The radio will scan only to statians that are in the
selected band and only to those with a strong signal.
3-45