Cleaning And Care - Electrolux EHC7240BA User Manual

Cleaning and care

Clean the appliance after each use.
Always use cookware with clean bottom.
Scratches or dark stains on the glass-
ceramic cause no effect on how the
appliance operates.
To remove the dirt:
1. Remove immediately:
tic, plastic foil, and food with sugar. If
not, the dirt can cause damage to the
appliance. Use a special
for the glass . Put the
What to do if ...
Problem
You cannot activate the appli-
ance or operate it.
A Sound operates and the ap-
pliance deactivates.
A sound operates when the ap-
pliance is deactivated.
The appliance deactivates.
The residual heat indicator
does not comes on.
The Automatic Heat Up func-
tion does not operate.
The sensor fields become hot.
comes on
and number comes on.
 !            
     !        
              
             
           
melted plas-
scraper( option to buy)
scraper on the
Activate the appliance again and set the heat setting in 10 sec-
onds.
You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
The Child Safety Device or the Lock or Stop+Go operates. See
the chapter Operating instruction.
There is water or fat stains on the control panel. Clean the con-
trol panel.
You put something on one or more sensor fields. Remove the ob-
ject from the sensor fields.
You put something on the
field.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone should be hot, speak to the service cen-
tre.
There is still residual heat on the cooking zone. Let the cooking
zone become sufficiently cool.
The highest heat setting is set. The highest heat setting has the
same power as the Automatic Heat Up function.
The cookware is too large or you out it too near to the controls.
Put large cookware on the rear cooking zones if it is necessary.
The Automatic Switch Off operates. Deactivate the appliance and
activate it again.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some
time. Disconnect the fuse from the electrical system of the house.
Connect again. If
tre.
glass surface at an acute angle and
move the blade on the surface .
– Remove after the appliance is
sufficiently cool:
water rings, fat stains, shiny metallic
discolorations. Use a special cleaning
agent for glass ceramic or stainless
steel.
2. Clean the appliance with a moist cloth
and dishwashing liquid
3. At the end rub the appliance dry
with a clean cloth.
Possible cause and remedy
. remove object from the sensor
comes on again, speak to the service cen-
 !       !   
!            
           !   
            
           
electrolux 11
limescale rings ,
detergent.