Advertisement
4. Connect all cables as required - see "Rear connections" below.
Rear connections
The rear connectors are:
1. FUSE
2. Power Input
3. DVI-1 Input
4. DVI-2 Input
5. VGA-1 Input
6. VGA-2 Input
7. CVBS-1 Input (Composite Video) for AV input
8. CVBS-2 Input (Composite Video) for AV input
9. CVBS-3 Input (Composite Video) for AV input
10. RS232 Input
11. USB for Touch control (option)
Planning the installation
Before you install your display, the following points should be considered:
• Power requirements.
• Display location and mounting options.
• Additional accessories, e.g. keyboard or speakers.
Power requirements
Your Sunlight Viewable display is designed to run on boat's DC power systems rated at 12
V or 24 V. The MarinePC MPC-SL121W is equipped with 9~36V DC wide range power input.
The DC power system should be either:
• Negative grounded, with the negative battery terminal connected to the boat's
ground,
• Floating, with neither battery terminal connected to the boat's ground.
Grounding the display
It is important that an effective radio frequency (RF) ground is connected to the display.
You must ground the display by connecting the drain wire (shield) of the power input
cable to the nearest ground point of the boat's RF ground system.
Page 13
Advertisement
