Rayco RG74T-R Operator, Service, Maintenance Manual page 27

Remote Function
4 8
6 10
12
13
(1). Remote Control Power
(2). Push to start machine.
(3). Stop engine.
(4). Raise / Lower the Cutter Boom.
(5). Cutter Boom swing left / right.
(6). Left Track Forward / Reverse.
(7). Right Track Forward / Reverse.
(8). Cutter Wheel On / Off.
(9). Engine Throttle.
(10). Command Cut Adjustment Toggle. (Cutter Boom
swing speed)
(11). Tracks in / Tracks out. (To fit in tighter spaces)
(12). Raises the Blade.
(13). Command Cut Adjustment Switch / Cutter on
Deadman Switch.
(14). Machine 2-Speed. (Faster Travel Speed)
(15). Lower the Blade.
800.392.2686
3
9
2 11 7
14
15
Linking Procedures
In the event that you need to (re)link the transmitter and
receiver together. Open side compartment, located next to the
5
hydraulic tank as shown, and follow the steps listed below :
1
• Disconnect gray (a) & black (b) connector to the boom
LCM.
• Remove the Receiver Board from the boom LCM
enclosure with a screwdriver or similar metal object. Press
the "config" button (c) located on the corner of the board.
• Remove the battery door on the Transmitter and depress
and hold the button located on the rim of the compartment
just under the battery door. (d)
Note: Both the transmitter & receiver need to have power.
• Re-connect the gray (b) & black (a) connectors to
connect power from both the Transmitter and Receiver.
The Receiver will then scan each channel looking for
activity. Once it locates the transmitter you will see the
RG74T-R Operator · Service · Maintenance
d
Operation
a
b
c
e
27