Table of Contents
Advertisement
3-6
Removing and Installing the Hard Disk Drive
Read the following guidelines before you begin to install the hard disk drive:
• Take note of the drive tray orientation before sliding it out.
• The tray will not fit back into the bay if it is inserted incorrectly.
• Make sure that the HDD is connected to the HDD connector on the backplane.
Follow these instructions to install a hard disk drive:
1.
Press the release button.
2.
Extend the locking lever.
3.
Pull the locking lever in the direction of the arrow to remove the HDD tray.
4.
Slide the hard disk into the HDD tray.
5.
[For 3.5" hard drives]: Install 4 screws to both sides of the hard drive tray to secure the hard drive to
the HDD tray.
[For 2.5" hard drives]: Install 4 screws to the bottom side of the hard drive tray to secure the hard
drive to the HDD tray.
6.
Reinsert the HDD tray into the slot and close the locking lever.
3.5" Hard Drive
System Hardware Installation
3
1
- 32 -
2
Advertisement
Table of Contents
