Siemens WM14UT89GB User Manual And Installation Instructions page 40

Table of Contents

Advertisement

en Troubleshooting
Fault
The door cannot
be opened.
The water is not drain-
ing.
Water is not flowing
in. Detergent is not
being dispensed.
40
Cause and troubleshooting
Select a suitable programme for draining.
→ "Programmes", Page 24
Power failure.
Open the door using the emergency release.
→ "Emergency release", Page 45
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
not kinked or trapped.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 33
The water outlet hose is connected too high.
Install the water outlet hose at a maximum height of
1 metre.
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
Unapproved extension installed on the water drain
hose.
Remove any unapproved extensions from the water
hose. Connecting the appliance
You have not pressed Start/Reload.
Press Start/Reload.
The filters in the water inflow are blocked.
Clean the filters in the water inflow.
The tap is turned off.
Turn on the tap.
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
jammed.

Advertisement

Table of Contents
loading

Table of Contents