Philips WelcomeEye Connect 2 User Manual page 12

4. Installation of the main or additional intercom panel
Note:
The product must not be connected to the power supply before the wiring has been
completed.
1
4
DES 9900 VDP
5 3 1 0 0 6
1 2
1 2
1 2 3 4 5 6 7 8
1 2
DES 9901 VDP
Avidsen
5 3 1 0 0 6
37200 TOURS 19 avenue Marcel Dassault
FRANCE
20V 110mA
RFID 125kHz
IP44
7
1 - Remove the tamper-resistant screw from the intercom panel.
2 - Tip the intercom panel cover forward.
3 – The intercom's lens should be approximately 1.60m above the ground.
4 – Mark the locations.
5 - Drill.
6 - Use pegs adapted to the nature of the support (the screws supplied are suitable for
solid walls).
7 – Connect the two wires from the monitor and, if necessary, connect the electric strike
plate and the gate (see section 1. Wiring). Configure the switches at the back of the
intercom panel (see section 2. Configuring the intercom).
8 – Insert the screws and refit the two caps concealing the retaining screws.
Note:
screw through the black covers on the back of the intercom panel without removing them.
EN8
2
5
2 1
2
8
WelcomeEye Connect 2 / Touch / V1
3
6
1
9
*
1m60