Table of Contents
Advertisement
To Unlock the System After a Power Loss
When battery power is reapplied to a secured radio, the
radio won't turn on and LOC will appear on the display.
Enter your secret code as follows; pause no more than
15 seconds between steps.
1. Turn the ignition on (radio off).
2. Press the SET button. The display will show "OOO."
3. Enter the six digits of the code following steps 6-9
under "To Set the Anti-Theft System." The display
will show the numbers as entered.
4. Press the AM FM button. If the time appears, the
disabling sequence was successful. If the display
indicates SEC, the numbers did not match and the
unit is still secured.
Disabling the Anti-Theft System
1.
2.
3.
4.
5.
6.
7.
Press PREV and FF together for five seconds with
the ignition on and the radio power off. The display
will show SEC, indicating the unit is in the
"secured" mode. (If
"---"
appears on the display,
the anti-theft system has already been disabled.)
Press the SET button. The display will show "000."
Press and hold SEEK until the first digit of your
code appears.
Press and hold SCAN until the second and third
digits of your code appear.
Press the AM FM button. The radio
will display
"000."
Repeat steps 3 and 4 to enter the second three digits
of the code. The display will show the numbers as
entered.
Press the AM FM button. If "---," then the time
appears, the disabling sequence was successful (the
numbers matched the secret code) and the unit is in
the "unsecured" mode. If the display shows SEC, the
disabling sequence was unsuccessful (the numbers
did not match) and the unit will remain in the
"secured" mode.
Advertisement
Table of Contents
