Page 2
NOTE Please check you have all hardware before assembling. If you are missing any hardware, please contact the store of purchase. Please ensure you have the name of the item, required hardware part and quantity. Please retain your receipt as proof of purchase to validate your warranty. CAUTION Do not tighten screws before all screws are in the right place.
STEP 1 Fix eight (8) PINS (B) into the outer pre-drilled holes on your back panel with your screwdriver. NOTE: these pre-drilled holes are slightly offset to the edge. BACK PANEL STEP 2 Fix four (4) PINS (B) into the outer pre-drilled holes at the tops of your end panels as shown Knock in your ARRERTS (A) into the pre-drilled holes on the inside of your end panels.
Page 4
STEP 3 Align the CAM HOUSING on your end panels with your PINS (B) on your back panel. Tighten by rotating the screw to the RH. Repeat this step with your top panel. CAM HOUSING STEP 4 Place the assembled unit to its required position and insert SCREWS (C) into the top of your ARRET (A) and drive into top with force using your screw driver NOTE: Be careful not to over tighten.
Page 5
STEP 5 To insert shelves, place your SHELF SUPPORTS (D) in the holes on the end panels at the desired shelf height and the shelf sits on top 5 / 5...