Installation Instruction; Select The Best Location; Mono Bloc Unit Installation - Panasonic WH-MDC012H6E5 Service Manual

Installation Instruction

Mono Bloc Unit

Handling of Mono bloc unit
Mono bloc unit is a large and heavy apparatus.
o
The handling of the unit only to be done by
lifting tools with slings. These slings can be
fitted into sleeves at the unit's base frame.

Select the Best Location


Install the Mono bloc unit in outdoor locations only.

Avoid installations in areas where the ambient
temperature may drop below -20°C.

The Mono bloc unit must be installed on a flat,
solid surface.

A place removed from any heat source or steam
which may effect the operation of the Mono bloc
unit.

A place where air circulation is good.

A place where drainage can be easily done.

A place where Mono bloc unit's operation noise
will not cause discomfort to the user.

A place which is accessible for maintenance.

Ensure to keep minimum distance of spaces as
illustrated above from wall, ceiling, or other
obstacles.

A place where flammable gas leaking might not
occur.

A place where the Mono bloc unit's piping and
wiring lengths come within reasonable ranges.

If an awning is built over the unit to prevent direct
sunlight or rain, be careful that heat radiation from
the condenser is not obstructed.

Do not place any obstacles which may cause a
short circuit of the discharged air.

Avoid installing the Mono bloc unit at a location
where suction side may be exposed directly to
wind.

If Mono bloc unit installed near sea, region with
high content of sulphur or oily location (e.g.
machinery oil, etc.), it lifespan maybe shorten.

When installing the product in a place where it will
be affected by typhoon or strong wind such as
wind blowing between buildings, including the
rooftop of a building and a place where there is no
building in surroundings, fix the product with an
overturn prevention wire, etc. (Overturn prevention
fitting model number: K-KYZP15C)

Mono Bloc Unit Installation

Mono bloc unit will become heavy when filled with
water. Please install the unit on a strong concrete floor
and consider the weight of the unit and water.

Fix Mono bloc unit on the concrete floor with M12
anchor bolt at 4 locations.

Pull-out strength of these anchor bolts must be
above 15000N.
Anchor bolt
Broken stone
Floor
Concrete
Embedded anchor bolt
Floor slab (concrete)
•
Compress strength of concrete is ab ove 18MPa {180kgf/cm
Illustration of grip type and embedded type anchor bolt
Grip anchor bolt
60mm or more
300mm or
more
Anchor bolt
80mm
Above
20mm
2 }