Installation Of Remote Controller; Installation Location - Panasonic WH-MDC012H6E5 Service Manual

11.1.5

Installation of Remote Controller

11.1.5.1

Installation Location


Install at the height of 1 to 1.5 m from the floor (Location where average room temperature can be detected).

Install vertically against the wall.

Avoid the following locations for installation.
1 By the window, etc. exposed to direct sunlight or direct air.
2 In the shadow or backside of objects deviated from the room airflow.
3 Location where condensation occurs (The Remote Controller is not moisture proof or drip proof.)
4 Location near heat source.
5 Uneven surface.

Keep distance of 1 m or more from the TV, radio and PC. (Cause of fuzzy image or noise)
11.1.5.2 Remote Controller Wiring

Remote Controller cable shall be (2 x min 0.3 mm
Total cable length shall be 50 m or less.

Be careful not to connect cables to other terminals (e.g. power source wiring terminal). Malfunction may occur.

Do not bundle together with the power source wiring or store in the same metal tube. Operation error may occur.
11.1.5.3 Mounting The Remote Controller
For exposed type
Preparation: Make 2 holes for screws using a driver.
Mono bloc unit
Remote Controller
wiring (field supply)
•
No polarity
Terminal for Remote Controller wiring
2
), of double insulation PVC-sheathed or rubber sheathed cable.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Cut here with
a nipper and
remove the burr
with a file.
Claw (2 places)
Screw
(field supply)
Connect the remote control
wiring
•
Arrange the wires along the groove
of the case.
55
Remote Controller
1
2
Mount the bottom case to
the wall.
U P
Wall to which
the remote
controller is
fixed
Hole for screw
Claw (2 places)