Mounting The Remote Controller; Replace The Remote Controller Cover - Panasonic WH-ADC0916H9E8 Service Manual


Remove the wiring between Remote controller
and Tank Unit terminal.
Claw
(2 places)
Disconnect the
Remote controller
wiring
11.1.7.4 Mounting The Remote
Controller
For exposed type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Cut here with
a nipper and
remove the burr
with a file.
Claw (2 places)
Screw
(field supply)
Connect the remote control
wiring
•
Arrange the wires along the groove
of the case.
Top case
(Back side)
Bottom case
(Back side)
Mount the bottom case to
the wall.
U P
Wall to which
the remote
controller is
fixed
Hole for screw
Claw (2 places)
Clamper
(field supply)
Pass through
the hole
Remote controller terminal board
Remove the coating. Approx. 6 mm
Remove the sheath. Approx. 180 mm.
Make sure the wiring connection is in the
correct direction.
For embedded type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Avoid the wire
being caught.
Claw (2 places)
Connect the remote
control wiring
11.1.7.5 Replace The Remote Controller
Cover

Replace the existing Remote controller cover with
Remote controller cover to close the hole left after
remove the Remote controller.
1 Release the Remote controller cover's hooks
from behind the Front Plate.
Front Plate
Existing Remote
controller cover
70
Mount the bottom case
to the wall.
•
Pass the wire through the hole
in the centre of the bottom case.
U P
Hole for
screw
Claw (2 places)
Screw
(field supply)
Remote controller
terminal board
Remove the coating.
Top case
(Back side)
Bottom case
(Back side)
Make sure the wiring
connection is in the correct
direction.
Hook (6 places)
Approx. 6 mm