CartTek Yellowstone User Manual page 9

4. Install Handle assembly onto axle as shown below. Slide nylon
end of the handle into it's location, aligning the through holes.
Install pivot bolt as shown. Press the two halves of the connector
together to complete the data line. You should hear a slight click.
5. Install rear anti-tip wheel. Under axle pull out the anti-tip wheel
lock pin and slide anti-tip wheel in frame until locked.
6. Lift handle from lower caddy frame. You may need to lightly
hold down lower frame with your foot.
7. Lift upper handle and extend handle fully to desired position.
Lock into position with black locking knob located behind the
upper bag rest.
8. Place battery in tray. Insert battery cable into battery port,
making sure to align pins.
9. Load golf bag onto caddy bottom first. Balance weight of golf
bag equally 'side to side'. Secure golf bag with bungees.
10. Securing your golf bag on the cart locks the cart in the "open"
position. It is important that both top and bottom bag straps
are tight, and your bag is firmly secured in the bag rests. If the
bungees are loose, and your golf bag is rotating in the bag rest,
you can tie a knot in the bungee to shorten the length, and
make it tighter.
9
carttek.com