TABLE OF CONTENTS INTRODUCTION BASIC SET-UP TURNING ON YOUR GRI-975LI FREE WHEEL MODE PRECAUTIONS BATTERY MAINTENANCE ALIGNMENT SYSTEM FOR WARRANTY, SPARE PARTS AND ACCESSORIES: Page 2 of 12...
INTRODUCTION Thank you for purchasing the CartTek GRI-975Li golf trolley. Your CartTek trolley cart was thoroughly quality control checked and road tested before being shipped to your address. We do everything possible to assure that your trolley is in perfect working order upon arrival. Should you have any issues or questions about the performance of your trolley, please contact us at don@carttekcanada.ca or 888-245-7835.
QUICK TIP After unpacking the trolley and while reading this manual, place the battery on charge while you assemble the unit. Plug battery into charger and charger into power source. The battery may be delivered with a charge but you should verify a full charge before using the trolley for the first time.
Page 5
Lift lower handle. Extend upper handle into desired position and secure by turning black locking knob. Load golf bag onto trolley. Balance weight of golf bag equally “side to side”. Secure golf bag with bungees. Securing your golf bag on the cart locks the cart in the “open”...
Distance Control Function: When the trolley is stopped, press and hold the LED until it flashes rapidly. Release the button, the GRI-975Li will move forward for 10 seconds at the currently set speed. (Distance control function will not work when cart is stopped via the speed dial.) Models with AMB - To engage the “parking brake”...
FREE WHEEL MODE In the event that you have a loss of power or have a need to pull the GRI-975Li backwards, you must put the Trolley into “Free Wheel Mode”. For “free wheel” mode depress button on hub and pull wheels out approximately 1/4 of an inch, making sure the wheels engaged into the axle.
CAUTION: Wheels can disengage in sharp turns or from excessive speed. BATTERY MAINTENANCE Your GRI-975Li Trolley comes with a 24 volt, 7.5 Ah Lithium Ion battery. Whenever possible we ship your battery fully charged. Before trying to operate your GRI-975Li, please verify that the battery is fully charged.
Page 9
Always ensure battery is connected to charger when connecting and disconnecting charger from power source. Your battery charger should not be left plugged into the power source when not in use. The charger has a green LED light when inserted into a power source if it does not have a battery connected to it.
Take precautions and be careful to not drop the battery. The battery casing could crack and the subsequent battery life will be severely compromised. Do not strain or pull on battery cable. Always push silver slide latch on round plug when inserting and removing from cart or charger.
Page 11
When standing in the front of the trolley looking at the front wheel, loosen the 17 mm nut on the right side of the front wheel. Depending on how the trolley is tracking, will determine which way to turn the Allen set screws. FRONT of Allen Set Screws Turn with Allan Wrench The Allen Set Screws should be gently turned on both the front...
Take the time to practice controlling trolley with the start stop switch on handle and using the distance control function. FOR WARRANTY, SPARE PARTS AND ACCESSORIES: Contact Us: 888-245-7835 http://www.carttekcanada.ca CartTek Canada 1372 Merrybrook Lane Oakville, Ontario L6M 1T4 email: don@carttekcanada.ca Page 12 of 12...
Need help?
Do you have a question about the GRI-975Li and is the answer not in the manual?
Questions and answers