City Model - Mercedes-Benz 2011 CL-Class Operator's Manual

Navigation
170
Road display
Road display active
Street name or street number, e.g. for
:
highways
Geo-coordinate display
Geo-coordinate display active
Current height above sea level, rounded
:
up
Current vehicle position: latitude
;
coordinates
Current vehicle position: longitude
=
coordinates
Number of GPS satellites currently being
?
used
There must be sufficient GPS reception for all
displays to be shown. If this is not the case,
the display will be grayed out. Height
display : may vary from the actual value,
because the navigation system uses the GPS
signal for the calculation.
When scrolling the map (
see the geo-coordinates of the crosshair
positions, but height display : and number
of satellites used ? are not displayed.
Y page 145), you will
"None" menu option
Display switched off
Currently set map orientation
:
i During the "Move map" function, you can
see additional data depending on the
position of the crosshair, such as a road
name, if the digital map supports this data.
Activating/deactivating the
topographical map
The topographical map shows different
heights using different colored height levels.
Generally, a color scale in which the colors
correspond to the natural coverage or colors
as seen from the air is used, e.g.:
green for flat land
R
yellow and brown for hills
R
gray and white for mountains
R
X
To show the menu: press the COMAND
controller W.
X
Select Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X
Topographical Map
Select
to confirm.
Depending on the previous state, switch
the option on O or off ª.
Switching the city model on/off
When the city model is switched on, the map
shows buildings in 3D.
i The city model is only shown in the "3D
map" map orientation.
It is available in the 50 m and 100 m map
scales.
and press W