Mounting Options; Ducting Options; Wiring Options - Broan LOSONE SELECT L900 Series Instructions Manual

MOUNTING OPTIONS

¼-20 hex nuts secure mounting brackets to housing. Loosen and
re-tighten or remove and replace nuts as necessary for desired
mounting bracket position.
Factory-shipped
Horizontal
discharge
22"
Mounting brackets in
factory-shipped position -
mounted directly to joists.
(Outlet parallel to joists.)
(New construction)
Housing Con-
verted to Vertical
Discharge
18"
Mounting brackets flipped
over and mounted to addi-
tional framing.
(Outlet vertical.)
(New or Existing construction)

WIRING OPTIONS

WIRING PLATE
POSITION
HORIZONTAL POWER
CABLE CONNECTION
Wiring plate mounts to side or top of housing.
Factory-shipped
Horizontal
1 / "
1
8
discharge
MAX.
18"
Mounting brackets flipped
ADUSTABLE FOR VARIOUS CEILING THICKNESSES
over and mounted to addi-
tional framing.
(Outlet perpendicular to joists.)
(New or Existing construction)
1½"
Factory-shipped
to
Horizontal
2½"
discharge
22"
Mounting brackets flipped
ADUSTABLE FOR VARIOUS CEILING THICKNESSES
over and mounted to top of
housing. Housing secured
with cables.
(Outlet parallel to joists.)
(New or Existing construction)
VERTICAL
POWER CABLE
CONNECTION

DUCTING OPTIONS

BLOWER DISCHARGE POSITIONS
DUCT
CONNECTOR
(this side)
1½"
to
2½"
Ventilator shown in
horizontal discharge
position. (Factory shipped)
DUCTING (Vertical blower discharge)
12" ROUND DUCT
8" X 12" TO
12" ROUND
TRANSITION
Typical ductwork connection to a ventilator converted to
USE AND CARE
Ventilator is designed for continuous operation. If desired, it may
be controlled using an on/off switch or a solid-state, variable speed
control. Follow wiring instructions packed with control, and adhere
to all local and state codes, and the National Electrical Code.
WARNING: To reduce the risk of electric shock,
disconnect from power supply before servicing.
To clean grille: Use appropriate vacuum attachment or remove
grille and clean with a soft cloth and mild soap or detergent. Dry
grille thoroughly before reinstalling.
To clean blower assembly: Remove grille, unplug blower from
housing, remove blower mounting nuts, and carefully remove blower
from housing. Use appropriate vacuum attachment or a soft cloth and
mild soap or detergent to clean blower discharge area and wheel.
DO NOT ALLOW WATER TO ENTER MOTOR. Make sure blower
assembly is completely dry before reinstalling.
Motor is permanently lubricated. Do not oil or disassemble motor.
LOSONE SELECT
L900 SERIES • L1500 SERIES
DUCT
CONNECTOR
(this side)
MOVABLE
PANEL
Ventilator shown in
vertical discharge position.
(Change movable panel to
new location as shown.)
ROOF CAP
vertical discharge.
®
Page 3
MOVABLE
PANEL
(Change to this
location)