Black & Decker Price Pfister Contempra R89-N Series Manual page 3

Tub & shower - shower only trim kit
Table of Contents

Advertisement

Available languages

Available languages

7
7A
7G
7D
7C
7E
7 TRIM FLANGE ATTACHMENT
Position Flange (7A) on Valve (7B) with Drain Hole (7C) at the bottom. Place
Protective Washer (7D) on the short end of the reversible Retainer Sleeve (7E).
Screw Retainer Sleeve (7E) onto threaded section of the Stem and Bonnet (
7E) onto threaded section of the Stem and Bonnet (
7E
Tighten Retainer Sleeve (7E) by hand until Flange (
7E) by hand until Flange (
7E
surface. If the short end of the Retainer Sleeve (7E) is too short, reverse it to
use the longer end.
8
8A
8D
8C
8E
8 HANDLE ATTACHMENT
Screw Stem Extender (8A) onto the Valve Stem (8B). Thread the Set Screw (8C)
into the Handle (8D) and thread it in only three to four turns. Place Handle (8D)
onto the Stem Extender (8A) and tighten the Set Screw (8C) by using the Hex
Wrench (8E) that is provided.
Wrench (
Wrench (
8E) that is provided.
8E
Make sure Set Screw (8C) is securely tightened to handle (8D).
7B
7C
7A) is snug to fi nished wall
7E) is too short, reverse it to
7E
8B
ENGLISH
9
9 SHOWER ARM INSTALLATION
Insert the end of Shower Arm (9A) through the Shower Flange (9B). Apply PTFE
plumber's tape to both ends of Shower Arm (9A) according to manufacturer's
instructions. Screw the end of Shower Arm (9A) into pipe elbow inside the wall.
Slide Shower Flange (9B) tight to the wall.
10
7E
7E).
7G).
10C
10 SPOUT INSTALLATION
Apply PTFE plumbers tape on both ends of Pipe Niple (10A) (not included).
Screw Pipe Niple (10A) into the elbow inside the wall and tighten with pipe
wrench. The Pipe Niple (10A) is to project 3
Position Flange (10D) onto fi nished wall with Drain Hole (10E) at the bottom.
Screw Tub Spout (10B) onto Pipe Niple (10A) and tighten until Spout is properly
positioned and fl ush with fl ange (10D).
11
11 UNIT START UP
Turn on hot and cold water supplies, and check all connections for leaks.
3
9B
9A
10A
10A
10D
10B
10E
) into the elbow inside the wall and tighten with pipe
) into the elbow inside the wall and tighten with pipe
7
7
/
" to 4" from the fi nished wall.
8
/ 8 " to 4 "
7
3
10E
10E) at the bottom.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Price pfister contempra 808-n series

Table of Contents