Pettec Modular Spray Trainer Quick Start Manual page 15

Connect a second training collar
1. Set the switch for selecting the training collar on the remote control
from 1 to 2.
2. Turn on the training collar and check the battery level.
Then press the »S« (Sensitivity) button on the training collar for several
3.
seconds until a »P« (Pairing) lights up on the display. The training col-
lar is now in connection mode for approxi mately 20 seconds.
Now take the Modular Remote and press the »Up« and »Light«
4.
buttons simultaneously for several seconds. The notification LED on
the remote control now flashes red three times in succession and
signals that the connection is ready.
5. Now the remote control connects to the training collar within a few
seconds. If the connection is successful, the notification LED on the
trainer lights up green.
To test, press the »Light« button on the remote control. If both devices
6.
are successfully connected, the two LEDs on the training collar now
flash.
7. Please start at step 1 if the connection between the remote control and
the training collar has failed.
Modular Remote
Modular Spray Trainer
15