Connecting The Remote And Trainer - Pettec Modular Spray Trainer Quick Start Manual

Connecting the remote and trainer

Important
• The Modular Spray Trainer can only be connected to the PetTec
Modular Remote, so you can also use the device for remote training.
The remote control Modular Remote is available separately!
https://pettec.de/shop/trainer/

• Read the instructions and safety instructions for the Modular Remote
carefully before use.
• Only connect and disconnect the Modular Remote if the training collar
has not been attached to the dog.
Tips
• Please fully charge the remote control and training collar before
connecting.
• The Modular Remote (sold separately) works with both training
collars, both the Modular Spray and the Modular Vibra Trainer
(sold separately).
• Up to 2 training collars can be connected to the Modular Remote.
Accordingly, you can use a Modular Vibra as well as a Modular Spray
Trainer combined with the Modular Remote.
Initial connection of remote control and a training
collar (remote training)
1. Turn on the training collar and check the battery level.
Then press the »S« (Sensitivity) button on the training collar for seve-
2.
ral seconds until a »P« (Pairing) lights up on the display. The training
collar is now in connection mode for approx. 20 seconds.
Now take the Modular Remote and press the »Up« and »Light«
3.
buttons simultaneously for several seconds. The notification LED on
the remote control now flashes red three times in succession and
signals that the connection is ready.
4. Now the remote control connects to the training collar within a few
seconds. If the connection is successful, the notification LED on the
trainer lights up green.
To test, press the »Light« button on the remote control. If both
5.
Note: See photo
gallery p. 29
13