Hyundai 2010 Azera Owner's Manual page 139

1
FEATURES OF YOUR HYUNDAI
126
B970C01TG-AAT
Automatic Operation
The FATC (Full Automatic Temperature
Control) system automatically controls
heating and cooling as follows:
1. Push the "AUTO" switch. The indicator
light will illuminate confirming that the
Face, Floor and/or Bi-Level modes as
well as the blower speed and air condi-
tioner will be controlled automatically.
The air conditioning will operate if am-
bient temperature is higher than
34.7°F(1.5°C) and automatically turns
off if the ambient temperature drops
below 33.08°F(0.6°C).
2. Push the "TEMP" button to set the de-
B970C03TG
sired temperature.
The temperature will increase to the
maximum "HI" by pushing on the
button. Each push of the button will
cause the temperature to increase by
1°F(0.5°C).
The temperature will decrease to the
minimum "LO" by pushing on the
button. Each push of the button will
cause the temperature to decrease by
1°F(0.5°C).
NOTE:
If the battery has been discharged or
disconnected, the temperature mode will
reset to 73 °F.
You can change the temperature mode
from Fahrenheit to Centigrade as fol-
lows;
Press the DUAL and MODE button si-
multaneously for 3 seconds.
The display shows that the unit of tem-
perature is adjusted to Fahrenheit or
Centigrade (°F → → → → → °C or °C → → → → → °F).
Photo Sensor
B970C04TG
NOTE:
Never place anything over the sensor
which is located on the instrument panel
to ensure better control of the heating
and cooling system.
B970C02TG-A