Hyundai 2008 Veracruz Owner's Manual page 246

Features of your vehicle
1. XM Selector
• The XM selector will turn to each mode
in the following order each time you
press the button.
- XM1 XM2 XM3
• When you press this button when you
are listening to CD or RADIO, the sys-
tem will automatically turn to XM
mode.
• When the ignition switch is set to ACC
(1st notch) or ON (2nd notch) and
when you press this button, XM will be
on even when the audio system was
turned off.
2. LCD (Liquid Crystal Display)
It displays the XM1, XM2, XM3, Preset
Number, Title of the Channel Received,
EQ Mode (CLASSIC, POP, ROCK,
JAZZ), and SCAN Status when listening
to XM.
4 164
3. SCAN Button
When you press this button, the player
will play 10 seconds of each channel
(LCD will display "SCAN"). Press it again
to cancel scanning. Also, press and this
button for more than 0.8 seconds to play
the channels memorized to the preset
buttons for 10 seconds each. (LCD will
display "corresponding channel number",
"<P>", and "SCAN".) Press it again to
cancel scanning.
4. Information Button
You can see the information of the chan-
nel currently received and you can switch
to different information by pressing this
button in the following order.
- Title Name Category
5. Channel Move (Seek Up/Down)
Button
• When you press this button, the chan-
nel will move automatically and stop at
the next available channel and play the
channel. The display will cycle once
through the Channel, Title, Name and
Category for selected channel.
(Press [ ] to move to the higher fre-
quencies, press [
quencies automatically.)
Press and hold either the down or up at
a fast rate. The display will show the
Channel Name and Number while tun-
ing at the fast rate.
• Radio ID :Seek or tune to XM channel
0 to display the Radio ID.
Current
State
] to the lower fre-