Indicator Light - LC-POWER LC-M27-4K-UHD-144 Manual

Overclocking Limita�ons:
1. Requires two DP 1.4 cables connected (see Important resolu�on informa�on
above)
2. HDR, Adap�ve-Sync and PIP/PBP will be disabled and unusable.
To Enable Overclocking
1. Connect both DisplayPort (DP) cables from the media host (game console,
projectors, etc.) to the monitor.
2. Turn on the feature from the OSD menu by following these steps: OSD -->
Other --> UHD 144 MODE --> On.
Check with your graphics card documenta�on to determine the highest
refresh rate your GPU is capable of outpu�ng and what, if any, addi�onal
system se�ngs need to be adjusted.
Adap�ve-Sync
This feature is off by default. To ac�vate, you must have hardware with
Adap�ve-Sync capability, a DP or HDMI cable, and the latest graphic drivers.
A�er connec�ng your computer and monitor with a DP or HDMI cable, you
may receive a prompt to enable the feature on your computer. If you do not,
you may need to enable the func�on in your graphics card menu. See your
graphics card manufacturer's documenta�on for instruc�ons.
Adap�ve-Sync will be disabled and unusable when overclocking the
monitor to get 4K (UHD) resolu�on at 144Hz refesh rate (see
Overclocking Limita�ons above).
8. lndicator Light
Solid white light indicates power is on and the monitor is opera�ng normally.
Flashing white light indicates no video source, no horizontal or ver�cal signal
has been detected or voltage is low. Please ensure your computer is on and
all video cables are fully inserted and/or connected.

Indicator Light

Eng-7