Hyundai 2005 Tiburon Owner's Manual page 90

B970C02E-AAT
Automatic Operation
The FATC (Full Automatic Temperature Con-
trol) system automatically controls heating and
cooling as follows:
1. Push the "AUTO" switch. The indicator light
will illuminate confirming that the Face, Floor
and/or Bi-Level modes as well as the blower
speed and, air conditioner will be controlled
automatically.
2. Push the "TEMP" button to set the desired
HGK2106
temperature.
The temperature will increase to the maxi-
mum 90°F(32°C) by pushing on the
Each push of the button will cause the tem-
perature to increase by 1°F(0.5°C).
The temperature will decrease to the mini-
mum 62°F(17°C) by pushing on the
Each push of the button will cause the tem-
perature to decrease by 1°F(0.5°C).
NOTE:
If the battery has been discharged or dis-
connected, the temperature mode will reset
to centigrade degrees.
This is a normal condition and you can
change the temperature mode from centi-
grade to farenheit as follows;
Press the TEMP button down 3 seconds or
OUTSIDE
more with the
TEMP
display shows that the unit of temperature
is adjusted to centigrade or fahrenheit.
(°C → → → → → °F or °F → → → → → °C)
HGK2103
button.
Photo sensor
button.
NOTE:
Never place anything over the sensor which
is located on the instrument panel to en-
sure better control of the heating and cool-
ing system.
1
FEATURES OF YOUR HYUNDAI
79
button held down. The
HGK2076