Hummer 2007 H2 Owner's Manual page 65

CAUTION:
{
Children can be seriously injured or
strangled if a shoulder belt is wrapped
around their neck and the safety belt
continues to tighten. Secure any unused
safety belts behind the child restraint so
children cannot reach them. Pull the
shoulder belt all the way out of the
retractor to set the lock, if your vehicle has
one, after the child restraint has been
installed. Be sure to follow the instructions
of the child restraint manufacturer.
Notice: Contact between the child restraint or
the LATCH attachment parts and the vehicle's
safety belt assembly may cause damage to
these parts. Make sure when securing unused
safety belts behind the child restraint that
there is no contact between the child restraint
or the LATCH attachment parts and the
vehicle's safety belt assembly.
Folding an empty rear seat with the safety
belts secured may cause damage to the safety
belt or the seat. When removing the child
restraint, always remember to return the safety
belts to their normal, stowed position before
folding the rear seat.
Second Row Center Position — SUT
1. If the child restraint manufacturer recommends
that the top tether be attached, attach the top
tether to the top tether anchor, if equipped.
Refer to the child restraint instructions and the
following steps:
1.1. To access the top tether anchor, raise
the passenger side seat cushion by
pulling up on the strap loop at the rear
of the seat cushion and fold the
seat cushion forward. Then fold the
seatback forward. See 60/40 Split
Bench Seat on page 15 for additional
information.
1.2. Place the child restraint in the center
seating position.
1.3. Find the top tether anchor at the rear
base of the center seat.
65